-----BEGIN PGP SIGNED MESSAGE-----
AUSCERT External Security Bulletin Redistribution
ESB-2004.0295 -- US-CERT Technical Cyber Security Alert TA04-111A
Vulnerabilities in TCP
22 April 2004
AusCERT Security Bulletin Summary
Product: Systems that rely on persistent TCP connections
Impact: Denial of Service
Access Required: Remote
CVE Names: CAN-2004-0230
- --------------------------BEGIN INCLUDED TEXT--------------------
- -----BEGIN PGP SIGNED MESSAGE-----
Technical Cyber Security Alert TA04-111A archive
Vulnerabilities in TCP
Original release date: April 20, 2004
Last revised: --
* Systems that rely on persistent TCP connections, for example
routers supporting BGP
Most implementations of the Border Gateway Protocol (BGP) rely on the
Transmission Control Protocol (TCP) to maintain persistent
unauthenticated network sessions. There is a vulnerability in TCP
which allows remote attackers to terminate network sessions. Sustained
exploitation of this vulnerability could lead to a denial of service
condition; in the case of BGP systems, portions of the Internet
community may be affected. Routing operations would recover quickly
after such attacks ended.
In 2001, the CERT Coordination Center released CA-2001-09, describing
statistical weaknesses in various TCP/IP Initial Sequence generators.
In that document (<http://www.cert.org/advisories/CA-2001-09.html>),
it was noted by Tim Newsham:
[I]f a sequence number within the receive window is known, an
attacker can inject data into the session stream or terminate the
connection. If the ISN value is known and the number of bytes sent
already sent is known, an attacker can send a simple packet to
inject data or kill the session. If these values are not known
exactly, but an attacker can guess a suitable range of values, he
can send out a number of packets with different sequence numbers in
the range until one is accepted. The attacker need not send a
packet for every sequence number, but can send packets with
sequence numbers a window-size apart. If the appropriate range of
sequence numbers is covered, one of these packets will be accepted.
The total number of packets that needs to be sent is then given by
the range to be covered divided by the fraction of the window size
that is used as an increment.
Paul Watson has performed the statistical analysis of this attack
when the ISN is not known and has pointed out that such an attack
could be viable when specifically taking into account the TCP
Window size. He has also created a proof-of-concept tool
demonstrating the practicality of the attack. The National
Infrastructure Security Co-Ordination Centre (NISCC) has published
an advisory summarizing Paul Watson's analysis in "NISCC
Vulnerability Advisory 236929," available at
Since TCP is an insecure protocol, it is possible to inject
transport-layer packets into sessions between hosts given the right
preconditions. The TCP/IP Initial Sequence Number vulnerability
(http://www.kb.cert.org/vuls/id/498440) referenced in CA-2001-09 is
one example of how an attacker could inject TCP packets into a
session. If an attacker were to send a Reset (RST) packet for
example, they would cause the TCP session between two endpoints to
terminate without any further communication.
The Border Gateway Protocol (BGP) is used to exchange routing
information for the Internet and is primarily used by Internet
Service Providers (ISPs). For detailed information about BGP and
some tips for securing it, please see Cisco System's documentation
or Team Cymru (<http://www.cymru.com/>). A vulnerable situation
arises due to the fact that BGP relies on long-lived persistent TCP
sessions with larger window sizes to function. When a BGP session
is disrupted, the BGP application restarts and attempts to
re-establish a connection to its peers. This may result in a brief
loss of service until the fresh routing tables are created.
In a TCP session, the endpoints can negotiate a TCP Window size. When
this is taken into account, instead of attempting to send a spoofed
packet with all potential sequence numbers, the attacker would only
need to calculate an valid sequence number that falls within the next
expected ISN plus or minus half the window size. Therefore, the larger
the TCP Window size, the the larger the range of sequence numbers that
will be accepted in the TCP stream. According to Paul Watson's report,
with a typical xDSL data connection (80 Kbps, upstream) capable of
sending of 250 packets per second (pps) to a session with a TCP Window
size of 65,535 bytes, it would be possible to inject a TCP packet
approximately every 5 minutes. It would take approximately 15 seconds
with a T-1 (1.544 Mbps) connection. These numbers are significant when
large numbers of compromised machines (often called "botnets" or
"zombies") can be used to generate large amounts of packets that can
be directed at a particular host.
To protect against such injections, RFC 2385 provides a method of
using MD5 signatures on the TCP Headers. If this form of verification
is supported and enabled between two peers, then an attacker would
have to obtain the key used to transmit the packet in order to
successfully inject a packet into the TCP session. Another alternative
would be to tunnel BGP over IPSec. Again, this would provide a form of
authentication between the BGP peers and the data that they transmit.
The lack of authentication when using TCP for BGP makes this type of
attack more viable.
US-CERT is tracking this issue as VU#415294. This reference number
corresponds to CVE candidate CAN-2004-0230. NISCC is tracking this
issue as Advisory 236929.
Sustained exploitation of the TCP injection vulnerability with regard
to the BGP vulnerability could lead to a denial-of-service condition
that could affect a large segment of the Internet community. Normal
operations would most likely resume shortly after the attack stopped.
Since the TCP/IP Initial Sequence Number vulnerability (VU#498440) has
been proven more viable of an attack, any services or sites that rely
on persistent TCP sessions could also be affected by this
vulnerability. Impacts could range from data corruption or session
hijacking to a denial-of-service condition.
Apply a patch from your vendor
Please see you vendor's statement regarding the availability of
patches, updates and mitigation strategies.
Deploy and Use Cryptographically Secure Protocols
TCP initial sequence numbers were not designed to provide proof
against TCP connection attacks. The lack of cryptographically-strong
security options for the TCP header itself is a deficiency that
technologies like IPSec try to address. It must be noted that in the
final analysis that if an attacker has the ability to see unencrypted
TCP traffic generated from a site, that site is vulnerable to various
TCP attacks - not just those mentioned here. A stronger measure that
would aid in protecting against such TCP attacks is end-to-end
cryptographic solutions like those outlined in various IPSec
The key idea with an end-to-end cryptographic solution is that there
is some secure verification that a given packet belongs in a
particular stream. However, the communications layer at which this
cryptography is implemented will determine its effectiveness in
repelling ISN based attacks. Solutions that operate above the
Transport Layer (OSI Layer 4), such as SSL/TLS and SSH1/SSH2, only
prevent arbitrary packets from being inserted into a session. They are
unable to prevent a connection reset (denial of service) since the
connection handling will be done by a lower level protocol (i.e.,
TCP). On the other hand, Network Layer (OSI Layer 3) cryptographic
solutions such as IPSec prevent both arbitrary packets entering a
transport-layer stream and connection resets because connection
management is directly integrated into the secure Network Layer
The solutions presented above have the desirable attribute of not
requiring any changes to the TCP protocol or implementations to be
made. Some sites may want to investigate hardening the TCP transport
layer itself. RFC2385 ("Protection of BGP Sessions via the TCP MD5
Signature Option") and other technologies provide options for adding
cryptographic protection within the TCP header at the cost of some
potential denial of service, interoperability, and performance issues.
Ingress filtering manages the flow of traffic as it enters a network
under your administrative control. You can configure your BGP routers
to only accept packets on a specific network connection. Servers are
typically the only machines that need to accept inbound connections
from the public Internet. In the network usage policy of many sites,
there are few reasons for external hosts to initiate inbound
connections to machines that provide no public services. Thus, ingress
filtering should be performed at the border to prohibit externally
initiated inbound connections to non-authorized services. In this
fashion, the effectiveness of many intruder scanning techniques can be
Complex networks can benefit by separating data channels and control
channels, such as BGP, into different logical or physical networks.
Technologies such as VLANs, VPNs, leased links, NAT may all be able to
contribute to separating the tranmission of control information from
the transmission of the data stream.
Egress filtering manages the flow of traffic as it leaves a network
under your administrative control. There is typically limited need for
machines providing public services to initiate outbound connections to
In the case of BGP, only your BGP routers should be establishing
connections to your peers. Other BGP traffic generated on your network
could be a sign of an attempted attack.
Appendix A. Vendor Information
For vendor information, please see NISCC Vulnerability Advisory 236929
"Vulnerability Issues in TCP"
(http://www.uniras.gov.uk/vuls/2004/236929/index.htm) or Vulnerability
Note VU#415294 (http://www.kb.cert.org/vuls/id/415294#systems. As
vendors report new information to US-CERT, we will update the
vulnerability note. If a particular vendor is not listed in either the
NISCC advisory, or the vulnerability, we recommend that you contact
them for their comments.
US-CERT thanks Paul Watson, Cisco Systems and NISCC for notifying us
about this problem and for helping us to construct this advisory.
Feedback can be directed to the US-CERT Technical Staff.
April 20, 2004: Initial release
Last updated April 20, 2004
- -----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.1 (GNU/Linux)
- -----END PGP SIGNATURE-----
- --------------------------END INCLUDED TEXT--------------------
You have received this e-mail bulletin as a result of your organisation's
registration with AusCERT. The mailing list you are subscribed to is
maintained within your organisation, so if you do not wish to continue
receiving these bulletins you should contact your local IT manager. If
you do not know who that is, please send an email to firstname.lastname@example.org
and we will forward your request to the appropriate person.
This security bulletin is provided as a service to AusCERT's members. As
AusCERT did not write the document quoted above, AusCERT has had no control
over its content. The decision to follow or act on information or advice
contained in this security bulletin is the responsibility of each user or
organisation, and should be considered in accordance with your organisation's
site policies and procedures. AusCERT takes no responsibility for consequences
which may arise from following or acting on information or advice contained in
this security bulletin.
NOTE: This is only the original release of the security bulletin. It may
not be updated when updates to the original are made. If downloading at
a later date, it is recommended that the bulletin is retrieved directly
from the author's website to ensure that the information is still current.
Contact information for the authors of the original document is included
in the Security Bulletin above. If you have any questions or need further
information, please contact them directly.
Previous advisories and external security bulletins can be retrieved from:
If you believe that your computer system has been compromised or attacked in
any way, we encourage you to let us know by completing the secure National IT
Incident Reporting Form at:
Internet Email: email@example.com
Facsimile: (07) 3365 7031
Telephone: (07) 3365 4417 (International: +61 7 3365 4417)
AusCERT personnel answer during Queensland business
hours which are GMT+10:00 (AEST). On call after hours
for member emergencies only.
-----BEGIN PGP SIGNATURE-----
-----END PGP SIGNATURE-----